Table of Contents
Advertisement
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same
number of beeps will be applied to the beeper and LED in response to a good
read. For example, if you program this option to have five beeps, there will be
five beeps and five LED flashes in response to a good read. The beeps and LED
flashes are in sync with one another. To change the number of beeps, scan the
bar code below and then scan a digit (1-9) bar code and the Save bar code on
the
Programming Chart
inside the back cover of this manual. Default = One.
Number of Beeps/LED Flashes
Good Read Delay
This sets the minimum amount of time before the imager can read another bar
code. Default = 0 ms (No Delay).
* No Delay
Short Delay (500 ms)
Medium Delay (1,000 ms)
Long Delay (1,500 ms)
User-Specified Good Read Delay
If you want to set your own length for the good read delay, scan the bar code
below, then set the delay (from 0-30,000 milliseconds) by scanning digits from
the inside back cover, then scanning Save .
User-Specified Good Read Delay
2020/4820/4820i User's Guide
4 - 3
Advertisement
Table of Contents
