Connecting The Imager With Usb; Usb Pc Or Macintosh Keyboard - Hand Held Products HANDHELD 3800G User Manual

Connecting the Imager with USB

Note: Hand Held Products recommends connecting the imager end of the cable
first and the host end second.
An imager can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the imager and to the computer.
2. The imager beeps.
3. Verify the imager operation by scanning a bar code from the
Symbols in the back of this manual.
For additional USB programming and technical information, refer to the Hand
Held Products "USB Application Note," available at

USB PC or Macintosh Keyboard

The 3800g imagers are factory programmed for a USB interface. If this is your
interface and you do not need to modify the settings, skip to
If you programmed the imager for a different terminal interface and you want to
change to a USB Keyboard (PC) or USB Keyboard (Mac), scan one of the
following codes to program the 3800g. Scanning these codes adds a CR and
selects the terminal ID (USB PC Keyboard - 124, USB Macintosh Keyboard -
125).
USB Keyboard (PC)
1 - 2
Sample
www.handheld.com.
Chapter
USB Keyboard (Mac)
3800g User's Guide
3.