Crossover Ignition System; Crossover Ignition System Operations; Replace Igniter Batteries - Weber Vieluxe 27 Built-In Grill Owner's Manual

GENERAL MAINTENANCE
9. To reinstall the burners, reverse steps 3 through 8.
CAUTION: The burner openings (1) must be positioned properly over the valve orifices (2).
Check proper assembly before fastening manifold in place.
WARNING: After reinstalling the gas lines, they should be leaked-checked with a soap and water solution
before using the grill. (See page 19, "Check for gas leaks.")
Crossover ignition system operations
®
If the Crossover ® ignition system fails to ignite the left burner in a Heat Zone, light
the left burner with a match. If the left burner lights with a match, then check the
Crossover ® ignition system.
• Check that both ignition wires are attached properly.
• Check that the Crossover
• Replace battery with a like brand battery.
• You should hear the igniter sparking.
If the Crossover ® ignition system still fails to light, contact Customer Service toll free
at 1-866-VIELUXE SM .

Replace igniter Batteries

Parts required: 1 AA alkaline battery per igniter.
Unscrew igniter button from top of control panel. Remove igniter button and contact spring. Remove old battery and
replace with a new AA alkaline battery. Positive end of battery faces up as shown in illustration. Replace contact
spring and screw igniter button back down.
30
(2)
(1)
ignition button is activating.
®