Lighting The Rotisserie Burner; To Extinguish - Weber Vieluxe 27 Built-In Grill Owner's Manual

Built-in liquid propane gas grill
Hide thumbs Also See for Vieluxe 27 Built-In Grill:
Table of Contents

Advertisement

LIGHTING THE ROTISSERIE BURNER

Summary lighting instructions are printed on a card located inside of the door of grill.
WARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found
to be damaged in any way, do not use the grill. Replace using only Vieluxe
Contact Vieluxe
®
1
Open the lid.
2
Remove rotisserie cover by tilting the bottom of the cover towards you as you lift it off of the rotisserie burner.
Failure to open the lid while igniting the grill's burners, or not waiting 5 minutes to allow the gas to clear if
the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.
3
Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that
it is in the OFF position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF position when you turn on the LP cylinder valve, the
"excess gas flow control" feature will activate, limiting the flow of gas from the LP cylinder. If this should
occur, turn OFF the LP cylinder valve and burner control knobs. Then start over.
When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the
burners. After turning OFF the cylinder knob, wait at least 5 minutes for the gas to clear before attempting
to light the grill. Failure to do so may result in an explosive flame-up, which can cause serious bodily
injury or death.
4
Turn on the gas supply.
Vieluxe
®
27" Built-In
WARNING: Do not lean over the open grill.
5
Push rotisserie burner control knob down and turn to
HI/START. Continue to hold the control knob down.
Continue to next lighting step.
6
Push and hold down the igniter button until burner ignites.
You will hear the igniter sparking.
7
Continue to hold the control knob down for ten seconds
after the burner has ignited. Check that the burner is lit by
looking for the rotisserie burner to glow red.
WARNING: If the rotisserie burner does not light, turn the burner control knob to OFF and wait 5 minutes
to let the gas clear before you try again or try to light with a match.
Note - When using the rotisserie with the lid closed, only light two of the main burners that are directly under the
food being cooked. Use only the low setting.

To extinguish

Push down and turn the rotisserie burner control knob clockwise to OFF position. Turn gas supply OFF at
22
the LP cylinder or gas source.
Customer Service at 1-866-VIELUXE.
DANGER
DANGER:
Vieluxe
®
39" Built-In
5
®
authorized replacement hose.
6

Advertisement

Table of Contents
loading

Table of Contents