Crossover Ignition System Operations; Annual Maintenance - Weber Spirit Series Owner's Manual

CrossoVer iGnition sYstem operations
®
If the Crossover Ignition System fails to ignite the Front burner, light the Front burner
®
with a match . If the Front burner lights with a match, then check the Crossover
system .
• Check that both the white (1) and black (2) ignition wires are attached properly .
• Check that the Crossover ® ignition button pushes the igniter (button) down, and
returns to the up position .
If the Crossover ignition system still fails to light, contact the Customer Service
®
Representative in your area using the contact information on our web site .
Log onto www .weber .com .
®
◆

annuaL maintenanCe

inspection and Cleaning of the spider/insect screens
To inspect the Spider/Insect screens, remove the control panel . If there is dust or dirt on
the screens, remove the burners for cleaning the screens .
Brush the Spider/Insect screens lightly with a soft bristle brush (i .e . an old toothbrush) .
m Caution: do not clean the spider/insect screens with hard
or sharp tools. do not dislodge the spider/insect screens or
enlarge the screen openings.
Lightly tap the burner to get debris and dirt out of the burner tube . Once the Spider/
Insect screens and burners are clean, replace the burners .
If the Spider/Insect screen becomes damaged or cannot be cleaned, please contact the
Customer Service Representative in your area using the contact information on our web
site . Log onto www .weber .com ® .
burner flame pattern
The Weber ® gas barbecue burners have been factory set for the correct air and gas
mixture . The correct flame pattern is shown .
A) Burner tube (1)
B) Tips occasionally flicker yellow (2)
C) Light blue (3)
D) Dark blue (4)
If the flames do not appear to be uniform throughout the burner tube, follow the burner
cleaning procedures .
◆
maiNTENaNCE
® ignition
1
1
WWW.WEbEr.COm
2
2
3
4
® 19