Lighting The Smoker Burner - Weber Vieluxe 27 Built-In Grill Owner's Manual

LIGHTING THE SMOKER BURNER

Summary lighting instructions are printed on a card located inside of the door.
WARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found
to be damaged in any way, do not use the grill. Replace using only Vieluxe
Contact Vieluxe ® Customer Service at 1-866-VIELUXE.
1 Open the grill lid.
Failure to open the lid while igniting the grill's burners, or not waiting 5 minutes to allow the gas to clear if
the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.
2
Open smoker box lid
3 Fill smoker with water soaked wood chunks or chips.
4 Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that it
is in the OFF position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF position when you turn on the LP cylinder valve, the "excess
gas flow control" feature will activate, limiting the flow of gas from the LP cylinder. If this should occur,
turn OFF the LP cylinder valve and burner control knobs. Then start over.
When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the burners.
After turning OFF the cylinder knob, wait at least 5 minutes for the gas to clear before attempting to light the
grill. Failure to do so may result in an explosive flame-up, which can cause serious bodily
injury or death.
Note - Cover the rotisserie burner with rotisserie burner cover when not in use.
5 Turn on the gas supply.
Vieluxe ® 27" Built-In
16
DANGER
DANGER:
Vieluxe ® 39" Built-In
® authorized replacement hose.