To Extinguish; Manually Lighting The Smoker Burner - Weber Vieluxe 27 Built-In Grill Owner's Manual

Built-in liquid propane gas grill
Hide thumbs Also See for Vieluxe 27 Built-In Grill:
Table of Contents

Advertisement

WARNING: Do not lean over the open grill while lighting.
6
Push smoker burner control knob down and turn to
HI / START.
7
Push and hold down the Igniter button until burner
ignites.You will hear the igniter sparking.
8
Check that the burner is lit by looking through the cooking
grate.
DANGER: If the smoker burner does not light, turn the
burner control knob to OFF and wait 5 minutes to let the
gas clear before you try again or try to light with a match.
9
Close smoker cover after wood starts to smolder and turn
control knob to low.

To extinguish

Push down and turn the smoker burner control knob
clockwise to OFF position. Turn gas supply OFF at the
LP cylinder or gas source.

MANUALLY LIGHTING THE SMOKER BURNER

Summary lighting instructions are printed on a card located inside of the door of grill.
WARNING: Check hose before each use of grill for nicks, cracking, abrasions or cuts. If the hose is found
to be damaged in any way, do not use the grill. Replace using only Vieluxe
Contact Vieluxe
®
Customer Service at 1-866-VIELUXE.
1
Open the lid.
Failure to open the lid while igniting the burners, or not waiting 5 minutes to allow the gas to clear if the
grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.
2
Open smoker box lid.
3
Fill smoker with water soaked wood chunks or chips.
4
Make sure all burner control knobs are turned OFF. (Push control knob down and turn clockwise to ensure that it
is in the OFF position.)
WARNING: The burner control knobs must be in the OFF position before turning on the liquid propane
cylinder tank valve. If they are not in the OFF position when you turn on the LP cylinder valve, the "excess
gas flow control" feature will activate, limiting the flow of gas from the LP cylinder. If this should occur,
turn OFF the LP cylinder valve and burner control knobs. Then start over.
When the "excess gas flow control" feature is activated, a small amount of gas is still flowing to the burners.
After turning OFF the cylinder knob, wait at least 5 minutes for the gas to clear before attempting to light the
grill. Failure to do so may result in an explosive flame-up, which can cause serious bodily
injury or death.
DANGER
DANGER:
6
Control panel
Control panel
®
authorized replacement hose.
7
17

Advertisement

Table of Contents
loading

Table of Contents