Lighting The Rotisserie Burner - Weber Summit Series Owner's Manual

26

LIGHTING THE ROTISSERIE BURNER

ATTENTION: READ BEFORE
LIGHTING ROTISSERIE BURNER
After a period of non-use, before lighting the Rotisserie
Burner, a few seconds must pass for the gas supply
line to fi ll.
When holding the ignition button you will see a fl ash of
fl ames moving from right to left across the Rotisserie
Burner surface, the Rotisserie Burner is not lit until the
entire ceramic surface is afl ame.
At this point, start a count of 20 seconds before
releasing the Rotisserie Burner control knob.
The Rotisserie Burner surface will glow red once the
burner is fully ignited.
CAUTION: The Rotisserie Burner fl ame may be diffi cult
to see on a bright sunny day.
WARNING: Check hose before each use of grill for
nicks, cracking, abrasions or cuts. If the hose is found
to be damaged in any way, do not use the grill. Replace
using only a Weber ® authorized replacement hose.
Contact the Customer Service Representative in your
area using the contact information on our web site.
Log onto www.weber.com
1) Open the lid.
2) Remove the warming rack and the cooking grates from the cookbox.
Failure to open the lid while igniting the grill, or not
waiting 5 minutes to allow the gas to clear if the grill
does not light, may result in an explosive fl are-up
which can cause serious bodily injury or death.
OPERATING INSTRUCTIONS
® .
DANGER:
SUMMIT D
®
1
3
6
3
*The grill illustrated may have slight differences than the model
purchased.
8
4
5,7