HP Surestore Tape Library Model 2/20 User Manual page 106

104 Configuring the Library for Fibre Channel
7. Press when complete to save the changes, or select
[OK]
the beginning of the fibre configuration menu. If you select
message will display indicating the old values will be retained.
, a message will display indicating that the settings are
If you select
[OK]
being stored onto the Fibre Channel controller. If this is successful, a
message displays indicating that the new settings will be attempted at the
next restart.
8. To immediately apply the new settings, select
wait until the next power cycle.
When the Fibre Channel controller is restarted, or when the library is
power-cycled,
FUTURE SETTINGS
Fibre Channel controller always attempts to connect using
.
SETTINGS
If you select
[RESTART]
not be attempted if data transfers or library operations are in progress.
The operation normally completes within 90 seconds. The
[RESTART]
display will report the status of the operation when it is complete.
The actual connection achieved depends on the external
Note
topology and network. Consequently,
differ from
You can also change configuration from remote access. See
Note
Using the Remote Management Card
are copied into
, the Fibre Channel controller is restarted. This should
.
CURRENT SETTINGS
to return to
[QUIT]
, a
[QUIT]
, or select
[RESTART] [DONE]
. The
CURRENT SETTINGS
CURRENT
may
CURRENT STATUS
on page 96.
Chapter 3
to