Table of Contents
Advertisement
13
CEE configuration
Opening the CEE Configuration dialog box
1. Launch the CEE Configuration dialog box using one of the following methods:
•
•
•
FIGURE 105
2. Select the CEE switch, link aggregation group, or CEE port to perform one of the following
288
Select Configure > Switch > CEE from the menu bar.
Right-click the CEE switch from the device tree, and select Configure > CEE.
Right-click the CEE switch from the topology map and select Configure > CEE.
The CEE Configuration dialog box displays, showing the status of all CEE-related hardware and
functions.
NOTE
The Protocol Down Reason column displays only if the 10 Gbps CEE/FC switch module is
selected.
CEE configuration dialog box
converged enhanced Ethernet tasks, which are detailed later in this chapter.
•
"Adding a LAG"
on page 296
•
"Deleting a LAG"
on page 304
•
"Editing a LAG"
on page 301
•
"Enabling a CEE port or LAG"
on page 303
DCFM Professional User Manual
53-1001773-01
Advertisement
Chapters
Table of Contents
Troubleshooting
