Restoring Data To A New Server; Display; Resetting Your Display - HP Brocade BladeSystem 4/12 User Manual

3

Display

Restoring data to a new server

If your Management application server fails and you must recover information to a new server,
restore the data (Refer to

Display

You can reset the display to the default settings.

Resetting your display

You can reset your system to display the default display settings. Note that returning to current
settings after a reset may require configuring each global fabric or group setting individually. The
following table
state.
TABLE 5
Settings
Show port
Show connected end device
Map Layout
Line Types
Port Display
Map Flyovers
Product List
Table Column Order
To reset the Management application to the default display and view settings, complete the
following steps.
1. Select Server > Options.
2. Select Display in the Category list.
3. Click Reset Display.
4. Click Yes on the reset confirmation message.
5. Click Apply or OK to save your work.
66
"Restoring data"
(Table 5) details the settings that change with reset and the associated default
Default display settings
Default State
Disabled.
Set to Hide All.
Set to default for Groups.
Set to default for Groups.
Set to Attached Ports only.
Set to include the following properties:
•
•
Set to only display basic property list.
Set to default for open system.
The Options dialog box displays.
The display and view settings are immediately reset to the default display settings (as detailed
in the Default display Settings table
on page 65 for complete instructions).
Product Display—Name, Device Type, WWN, IP Address, and Domain ID.
Connection Display—Name (port), Address, Node WWN, Port WWN, and Port #.
(Table 5)).
DCFM Professional User Manual
53-1001773-01