Sflow Flow Max-Header; Sflow Sampling-Mode - HP 6125G Command Reference Manual

This command is supported only on physical Ethernet interfaces, but not on logical interfaces (such as
VLAN interfaces).
Examples
# Specify the collector number 2 on GigabitEthernet1/0/1 for flow sampling.
<Sysname> system-view
[Sysname] interface GigabitEthernet1/0/1
[Sysname-GigabitEthernet1/0/1] sflow flow collector 2

sflow flow max-header

Syntax
sflow flow max-header length
undo sflow flow max-header
View
Layer 2 Ethernet interface view
Default level
2: System level
Parameters
Length: Specifies the maximum bytes of a sampled packet that can be copied, in the range of 18 to 512.
Description
Use sflow flow max-header to set the maximum bytes of a sampled packet that can be copied (starting
from the header).
Use undo sflow flow max-header to restore the default.
By default, up to 128 bytes of a sampled packet that can be copied. HP recommends you use the default
value.
This command is supported only on physical Ethernet interfaces, but not on logical interfaces (such as
VLAN interfaces).
Examples
# Set the maximum bytes of a sampled packet that can be copied to 60.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] sflow flow max-header 60

sflow sampling-mode

Syntax
sflow sampling-mode { determine | random }
undo sflow sampling-mode
View
Layer 2 Ethernet interface view
173