Mirroring-Group Monitor-Port - HP 6125G Command Reference Manual

Examples
# Create remote source group 1, and configure port GigabitEthernet 1/0/1 as its egress port in system
view.
<Sysname> system-view
[Sysname] mirroring-group 1 remote-source
[Sysname] mirroring-group 1 monitor-egress GigabitEthernet 1/0/1
# Create remote source group 2, and configure port GigabitEthernet 1/0/2 as its egress port in
interface view.
<Sysname> system-view
[Sysname] mirroring-group 2 remote-source
[Sysname] interface GigabitEthernet 1/0/2
[Sysname-GigabitEthernet1/0/2] mirroring-group 2 monitor-egress

mirroring-group monitor-port

Syntax
mirroring-group group-id monitor-port monitor-port-id
undo mirroring-group group-id monitor-port monitor-port-id
View
System view
Default level
2: System level
Parameters
group-id: Number of a local or remote destination group, ranging from 1 to 4. The mirroring group
specified by group-id must already exist.
monitor-port-id: Port to be assigned to the specified mirroring group as the monitor port. The argument
takes the form of interface-type interface-number, where interface-type specifies the port type and
interface-number specifies the port number.
Description
Use mirroring-group monitor-port to assign a port to a local or remote destination group as the monitor
port.
Use undo mirroring-group monitor-port to remove the monitor port from the local or remote destination
group.
By default, no monitor port is configured for a mirroring group.
You cannot configure a monitor port for a remote source group.
You cannot assign a source port in an existing mirroring group to another mirroring group as the monitor
port.
Related commands: mirroring-group.
Examples
# Create local mirroring group 1, and configure port GigabitEthernet 1/0/1 as its monitor port.
<Sysname> system-view
[Sysname] mirroring-group 1 local
107