Ntp-Service Multicast-Server; Ntp-Service Reliable Authentication-Keyid - HP 6125G Command Reference Manual

ntp-service multicast-server

Syntax
ntp-service multicast-server [ ip-address ] [ authentication-keyid keyid | ttl ttl-number | version number ]
*
undo ntp-service multicast-server [ ip-address ]
View
VLAN interface view
Default level
3: Manage level
Parameters
ip-address: Sets a multicast IP address, which defaults to 224.0.1.1.
authentication-keyid keyid: Specifies the key ID to be used for sending multicast messages to multicast
clients, where keyid is in the range of 1 to 4294967295. This parameter is not meaningful if
authentication is not required.
ttl ttl-number: Specifies the TTL of NTP multicast messages, where ttl-number is in the range of 1 to 255
and defaults to 16.
version number: Specifies the NTP version, where number is in the range of 1 to 4 and defaults to 3.
Description
Use ntp-service multicast-server to configure the device to operate in NTP multicast server mode and use
the current interface to send NTP multicast packets.
Use undo ntp-service multicast-server to remove the configuration.
By default, the device does not operate in any NTP operation mode.
Examples
# Configure the device to operate in multicast server mode and send NTP multicast messages on
VLAN-interface 1 to the multicast address 224.0.1.1, using key 4 for encryption, and set the NTP version
to 3.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] ntp-service multicast-server 224.0.1.1 version 3
authentication-keyid 4

ntp-service reliable authentication-keyid

Syntax
ntp-service reliable authentication-keyid keyid
undo ntp-service reliable authentication-keyid keyid
View
System view
Default level
3: Manage level
25