Muting The Headset's Microphone; Using The Advanced Functions - Sennheiser DW Pro1 Instruction Manual

Using the headset system
6
Vol +
MUTE Mic
30
The volumes can be adjusted in several steps. When the minimum or
maximum volume is reached, you hear a double beep in the headset.
To increase or reduce the volume step-by-step, push the AUDIO
button backwards or forwards.
The assignment of the AUDIO button
on whether you wear the headset on the right or left ear (see
"Swapping the assignment of the AUDIO button
Vol –

Muting the headset's microphone

To mute the headset's microphone
base station lights up blue):
Press the AUDIO button
The microphone is muted. While the microphone is muted, you hear a
beep in the headset every 5 seconds and the LINK LED
station flashes red.
To unmute the headset's microphone:
6
Press the AUDIO button
You hear a low confirmation beep in the headset.
or
Disconnect the wireless link between headset and base station (see
page 23).
In both cases, the muting is canceled and the LINK LED
again or goes off.
¿

Using the advanced functions

Pairing additional headsets for shared use
You can use one DW series base station with different DW series
sets. This can be advantageous if you share a telephone workplace. The
last headset paired to the base station can be used without more ado.
If no wireless link is established between headset and base station:
Place the additional headset into the magnetic holder of the base
station.
During pairing of the headset to the base station, the HEADSET LED
flashes blue/red. If pairing was successful, the HEADSET LED
up blue. You can now use the newly paired headset.
* The DW series comprises the following products: DW Office, DW Office USB, DW Pro1/
Pro2, DW Pro1/Pro2 USB. The DW 800 is not part of the DW series.
can be swapped depending
during a call (the LINK LED
.
again.
" on page 16).
¿
on the
¿
on the base
¿
lights up blue
*
head-
lights