Putting The Headset On And Adjusting It - Sennheiser DW Pro1 Instruction Manual

Using the headset system
³
Left Right
24
You can also establish or disconnect the wireless link by pressing
»
the PC button
(depending on the selected mode
If your telephone has a built-in electronic hook switch supporting
the MSH standard (see page 13), you can only disconnect the wire-
less link between headset and base station by placing the headset
¿
into the base station. The control signals ("accept a call", "end a
call") of the headset are still transmitted to the electronic hook
switch without any restrictions.

Putting the headset on and adjusting it

Rotate the microphone boom as shown.
Carefully bend the flexible microphone boom so that the microphone
points towards your mouth.
Maintain a distance of about 0.8-1.2" (2-3 cm) between the micro-
phone and the corner of the mouth.
If you are using the Pro1 headset:
Put on the headset so that the ear pad
or right ear and that the headband
If you are using the Pro2 headset:
Put on the headset so that the ear pads
ears.
³
or the PHONE button
(PC or Phone), see page 28).
rests comfortably on your left
runs over the top of your head.
7
Pro1 Pro2
9
9
»
on the base station
rest comfortably on your
1
2-3 cm