Switching The Headset On/Off; Establishing A Wireless Link Between Headset And Base Station - Sennheiser DW Pro1 Instruction Manual

4
5
4
5
When the battery is about to run flat ...
... only the LED segment 1 lights up weakly or flashes (see page 9).
... the HEADSET LED flashes red.
... you hear a low battery warning (three beeps)in the headset.
... you have several minutes of battery reserve.
When the battery is flat, the headset switches off.
If the headset is outside the range of the base station, it will switch
off after 30 minutes in order to conserve battery power.

Switching the headset on/off

If you place the headset into the base station, the headset automat-
ically switches to standby mode. In standby mode, the power
consumption is very low and the radiated power is reduced to a
minimum. The HEADSET LED
Switching the headset on
Press and hold the LINK button
The HEADSET LED flashes blue 3 times and the wireless link to the
base station is established (where required). An ascending confirma-
tion beep is heard in the headset.
Switching the headset off
Press and hold the LINK button
The HEADSET LED flashes red 3 times.
Establishing a wireless link between headset and
base station
To establish a wireless link between headset and base station:
Press the LINK button
The link is established. The LINK LED
HEADSET LED flashes blue.
To disconnect a wireless link between headset and base station:
Press the LINK button
The link is disconnected. The LINK LED
go off.
Using the headset system
lights up blue during charging.
for 5 seconds.
for 5 seconds.
on the headset.
¿
lights up blue and the
on the headset.
¿
and the HEADSET LED
23