Adjusting The Volume - Sennheiser DW Pro1 Instruction Manual

¿
4
5
To start the conference call using the master headset:
Establish a wireless link between headset and base station (the LINK
¿
LED flashes blue).
To add a guest headset to the conference call:
Place the guest headset to be added to the conference call into the base
station of the master headset.
The HEADSET LED flashes blue/red and the headset pairs to the base
station. If pairing was successful, the HEADSET LED
Take the guest headset out of the base station.
You hear a beep in the master headset.
Press the LINK button
The guest headset is enabled for the conference call.
If necessary, repeat this procedure for the two other guest headsets.
Call the other party.
To exit the conference call with a guest headset:
Press the LINK button
To end the conference call:
Use the master headset to end the conference call.
The wireless links to all other headsets participating in the conference
call are disconnected.
You can only end the conference call using the master headset.
Other functions such as volume adjustment and muting the
headset's microphone can still be performed on each headset.

Adjusting the volume

WARNING Hearing damage due to high volumes!
Listening at high volume levels for long periods can lead to
permanent hearing defects.
Set the volume to a medium level.
Do not continuously expose yourself to high volumes.
In order to be able to adjust the volume of the ring tone and the acoustic
signals, the headset has to be in standby mode. In order to be able to
adjust the audio volume, a wireless link has to be established between
headset and base station (see page 23).
In PC mode, you can adjust the volume using the AUDIO button
or by using the volume control of your operating system (see the
instruction manual of your operating system).
Using the headset system
on the master headset within 15 seconds.
on the guest headset.
lights up blue.
29