1.
From the Home screen, scroll to and touch the
2.
Open the following menus:
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
●
3.
Touch the
option to set the fax dialing mode.
4.
Touch the
Set fax send speed
The Fax send speed setting sets the modem bit rate (measured in bits per second) of the Analog Fax
modem while sending a fax.
1.
From the Home screen, scroll to and touch the
2.
Open the following menus:
Fax Settings
●
Fax Send Settings
●
Fax Send Setup
●
Fax Dialing Settings
●
3.
Touch the drop down menu under the
following:
Fast
●
Medium
●
Slow
●
4.
Touch the
Set the redial interval
The redial interval setting selects the number of minutes between retries if the number dialed is busy
or not answering. Busy can also indicate a communication error.
NOTE:
You might observe a redial message on the control panel when the Redial-on-Busy, Redial-
on-No-Answer, and Redial-on-Error settings are set to off. This occurs when the fax accessory dials a
number, establishes a connection, and then loses the connection. As a result of this error condition,
the fax accessory performs two automatic redial attempts regardless of the redial settings (the first
one at 26,400 bps and, if that fails, a second one at 14,400 bps). During this redial operation, a
message appears on the control panel to indicate that a redial is in progress.
1.
From the Home screen, scroll to and touch the
2.
Open the following menus:
80
Chapter 3 HP Color LaserJet CM 4540 MFP Series, HP Color LaserJet Enterprise M4555 MFP
Series, HP LaserJet Enterprise 500 MFP Series, HP LaserJet Enterprise 500 Color MFP Series,
and HP LaserJet Enterprise M725 MFP Series
Dialing Mode
drop down menu and select either the
Save
button.
(default) — 33600 bps (bits per second)
— 14400 bps
— 9600 bps
Save
button.
Administration
Administration
Fax Send Speed
heading and then touch one of the
Administration
button.
Tone
option (default) or
button.
button.
Pulse
ENWW