Speakers - HP Envy 6 Maintenance And Service Manual

Remove the power connector cable:
1. Turn the computer, with the right side toward you.
2. Disconnect the power connector cable (1) from the system board.
3. Remove the double-sided tape (2) from the power connector.
4. Remove the power connector cable (3).
Reverse this procedure to install the power connector cable and bracket.

Speakers

Description
Speaker Kit (includes left and right speakers and cable)
Before removing the speakers, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
5. Remove the base enclosure (see
6. Disconnect the battery cable (see
60 Chapter 4 Removal and replacement procedures
Display panel on page
Base enclosure on page
Battery on page 36).
Spare part number
686598-001
32).
34).