Rtc Battery - HP Envy 6 Maintenance And Service Manual

RTC battery

Description
RTC battery
Before removing the RTC battery, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
5. Remove the base enclosure (see
6. Disconnect the battery cable (see
Remove the RTC battery:
1. Use a thin, non-conductive tool to remove the RTC battery from the socket on the system board.
NOTE:
system board.
2. Hold down the media card reader board (2), and remove the RTC battery (3). (The RTC battery
is also attached to the system board by foam material rather than double-sided adhesive.)
Use a thin, non-conductive tool to remove the RTC battery from the socket on the
Display panel on page
Base enclosure on page
Battery on page 36).
32).
34).
Component replacement procedures
Spare part number
686922–001
41