Power Button Board - HP Envy 6 Maintenance And Service Manual

Remove the speakers:
1. Turn the computer, with the front edge toward you.
2. Release the 2 Phillips PM 2.0×3.0 screws securing each speaker. (1)
3. Remove the speakers and cables (2).
Reverse this procedure to install the speakers.

Power button board

Description
Power button board
Before removing the Power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
5. Remove the base enclosure (see
6. Disconnect the battery cable (see
Spare part number
688003-001
Display panel on page
Base enclosure on page
Battery on page 36).
32).
34).
Component replacement procedures 61