Base Enclosure - HP Envy 6 Maintenance And Service Manual

9. Release the support strip (1) covering the display panel connector. Disconnect the display panel
cable from the display panel (2), and then remove the panel (3).
Reverse this procedure to install the display panel.

Base enclosure

Description
Base enclosure (Red)
Base enclosure (Black)
Base enclosure (Red)
Before disassembling the computer, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
34 Chapter 4 Removal and replacement procedures
Spare part number
686096–001
690197–001
689855–001
Display panel on page 32).