Rj-45 Module Cover - HP Envy 6 Maintenance And Service Manual

4. Remove the fan/heat sink (4).
Reverse this procedure to install the fan/heat sink..

RJ-45 module cover

Description
RJ-45 module cover
Before removing the RJ-45 module cover:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the display panel (see
5. Remove the base enclosure (see
6. Disconnect the battery cable (see
Remove the RJ-45 module cover:
1. Remove the 2 Phillips PM screws securing the RJ-45 module cover (1).
54 Chapter 4 Removal and replacement procedures
Spare part number
691642-001
Display panel on page
Base enclosure on page
Battery on page 36).
32).
34).