German Fire Brigade Panels - Panasonic EBL128 Planning Instructions

Panasonic Electric Works Nordic AB
MEW01090 Rev: 3
6.2.4
Fitted with a supplementary "O" ring gasket, it will comply
with IP61, in respect of dust and moisture. The unit has no
door, i.e. the front is accessed directly, when required. The
push buttons are disabled until they are supposed to be used.
The unit shall be wall mounted. Two compression glands are
attached. The front's designation texts are in Swedish. This
unit is intended for pre-warning, co-incidence
smoke / heat) alarm presentation. If there are two or more
alarms in the system, you can scroll amongst them but the fire
alarms can not be reset via this unit.
All or selected alarms will be presented in a display (alpha-
numeric LCD, 2x40 characters), with back-light. An alarm text
will also be presented together with each alarm, if programmed
in EBL128. Furthermore, at least 617 texts can for selected fire
alarms be stored in the unit and will in such a case be shown,
instead of the texts sent out from EBL128 for these alarms.
These text messages will be downloaded to the unit via
EBL128.
Any fault in the system will be presented as "General fault in
system". The buzzer will sound.
disablement in the system will be presented as "General
disablement in system".
A built-in buzzer will sound like in EBL128. The buzzer can be
silenced but the alarm devices in the installation can not be
silenced via this unit.
downloaded directly in the unit. The unit is power supplied
from EBL128 or an external power supply. The unit shall run
in S/W mode 1728 – 1587, which has the highest performance
with regard to functionality, response time, ability to store fire
alarms, etc.
The number of units that can be power supplied via EBL128 (or
an external power supply) is depending on all other units
connected to the same c.i.e. / external power supply. Up to
1200 m cable can be used. For more information, see Technical
description MEW00290.

German Fire Brigade Panels

See also "...optional Communication module (RS485 transceiver
component) 4552", page 14.
FBF 2003 German Fire
Bedienfeld). A grey metal housing (HxWxD, 185 x 255 x 58
mm) with a door. A key is required to open the door, which has
a Plexiglas ahead of the front. It has cable inlets on the top,
bottom and back sides and is intended to be wall mounted.
The function, LED indicators and push buttons on the front are
in accordance with DIN 14661. The front's designation texts
55
Two zone / address dependence.
EBL128 Planning Instructions V1.1.x
54
It can be silenced. Any
54
New software versions can be
Brigade Control
49
55
, fire (and heavy
Panel (Feuerwehr-