Table Of Contents - Panasonic EBL128 Planning Instructions

Panasonic Electric Works Nordic AB
MEW01090 Rev: 3

Table of contents

1 Introduction________________________________ 7
2 Definitions / Explanations ____________________ 9
2.1 PEWF&STE AB ___________________________________ 9
2.2 Alarm point _______________________________________ 9
2.2.1 Smoke detector ________________________________ 9
2.2.2 Analog detector ________________________________ 9
2.2.3 Sensor _______________________________________ 9
2.2.4 (Analog) Sensor Base (ASB) _____________________ 9
2.2.5 Conventional detector ___________________________ 9
2.2.6 Conventional Detector Base (CDB) ________________ 9
2.2.7 Addressable ___________________________________ 9
2.2.8 Old detector __________________________________ 10
2.2.9 Conventional zone line _________________________ 10
2.2.10 Addressable zone interface ______________________ 10
2.3 Output unit ______________________________________ 10
2.4 Output / Control output _____________________________ 10
2.5 Short circuit isolator _______________________________ 10
2.6 Display unit (D.U.) ________________________________ 10
2.7 COM loop _______________________________________ 10
2.8 Control Unit (C.U.) / C.I.E. __________________________ 10
2.9 Fire Brigade Panel (FBP) ___________________________ 10
2.10 Control panel (CP) ________________________________ 11
2.11 LED ____________________________________________ 11
2.12 External Indicator (LED) ___________________________ 11
2.13 Display / LCD ____________________________________ 11
2.14 Door open / Key switch _____________________________ 11
2.15 SSD / Site Specific Data ____________________________ 11
2.16 S/W / Software / System program _____________________ 11
3 Overview _________________________________ 12
3.1 The EBL128 c.i.e. _________________________________ 12
3.2 S/W Versions ____________________________________ 12
3.3 Documents ______________________________________ 12
3.4 Applications _____________________________________ 12
3.5 PC S/W _________________________________________ 12
4 Control & Indicating Equipment _____________ 13
4.1 COM loop _______________________________________ 15
4.1.1 A single break (cut-off) on the COM loop __________ 16
4.1.2 Several breaks (cut-offs) on the COM loop _________ 17
4.1.3 Short-circuit on the COM loop ___________________ 18
4.2 Programmable voltage outputs (S0-S1) ________________ 18
4.3 Programmable relay output (R0) ______________________ 19
4.4 Relay output for routing equipment (fault tx) (R1) ________ 19
EBL128 Planning Instructions V1.1.x
1