Static Route Edit - ZyXEL Communications P-870HN-5xb User Manual

12.2.1 Static Route Edit

Click the Add button in the Static Route screen. Use this screen to configure the
required information for a static route.
Figure 94 Static Route: Add
Figure 95 Static Route: Add: IPv6
The following table describes the labels in these screens.
Table 61 Static Route: Add
LABEL
IP Version
Destination IP
Address
Destination IP
address/prefix
length
IP Subnet
Mask
Use Interface
Use Gateway
IP Address
P-870HN-5xb User's Guide
DESCRIPTION
Select the IP version to use for this static route's traffic.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a
route to a single host, use a subnet mask of 255.255.255.255 in the
subnet mask field to force the network number to be identical to the host
ID.
If IPv6 is selected as the IP version, this parameter specifies the IPv6
network address and prefix length of the final destination. Routing is
always based on network number. If you need to specify a route to a
single host, use the prefix length of 128 to force the network number to
be identical to the host ID.
Enter the IP subnet mask here.
Select a WAN interface through which the traffic is sent. You must have
the WAN interface(s) already configured in the WAN screens.
Select this option and enter the IP address of the next-hop gateway. The
gateway is a router or switch on the same segment as your Device's
interface(s). The gateway helps forward packets to their destinations.
Chapter 12 Static Route
183