Using The Reset Button; The Wps Wlan Button; Turn The Wireless Lan Off Or On; Activate Wps - ZyXEL Communications P-870HN-5xb User Manual

Chapter 1 Introducing the Device

1.6.1 Using the Reset Button

Make sure the POWER LED is on (not blinking).
1
To set the device back to the factory default settings, press the RESET button for
2
ten seconds or until the POWER LED begins to blink and then release it. When the
POWER LED begins to blink, the defaults have been restored and the device
restarts.

1.7 The WPS WLAN Button

You can use the WPS WLAN button at the rear panel of the device to turn the
wireless LAN off or on. You can also use it to activate WPS in order to quickly set
up a wireless network with strong security.

1.7.1 Turn the Wireless LAN Off or On

Make sure the POWER LED is on (not blinking).
1
Press the WPS WLAN button for one second and release it. The WLAN/WPS LED
2
should change from on to off or vice versa.

1.7.2 Activate WPS

Make sure the POWER LED is on (not blinking).
1
Press the WPS WLAN button for more than five seconds and release it. Press the
2
WPS button on another WPS -enabled device within range of the Device. The
WLAN/WPS LED should flash while the Device sets up a WPS connection with the
wireless device.
Note: You must activate WPS in the Device and in another wireless device within two
minutes of each other. See
26
Section 7.10.4 on page 139 for more information.
P-870HN-5xb User's Guide