Setting Effects For A Patch (Effect) - Roland V-Synth XT Owner's Manual

How to Apply the LFO
● Apply the LFO gradually after the key is pressed
fig.LFO-1.e
Delay
high (more)
Time
Pitch
Cutoff Frequency
Level
Pan
Note on
low (less)
Fade Mode: ON <<
Fade Time: The time over which the LFO amplitude will reach the
maximum after the Delay Time has elapsed.
Delay Time: The time from when the keyboard is played until the
LFO begins to be applied.
● Apply the LFO immediately when the key is
pressed, and then gradually begin to
decrease the effect
fig.LFO-2.e
high (more)
Delay Time
Pitch
Cutoff Frequency
Level
Pan
Note on
low (less)
Fade Mode: ON >>
Fade Time: The time over which the LFO amplitude will reach the
minimum after the Delay Time has elapsed.
Delay Time: The time that the LFO will continue after the keyboard
is played.
● Apply the LFO gradually after the key is released
fig.LFO-3.e
Delay
high (more)
Time
Pitch
Cutoff Frequency
Level
Pan
Note Note
on off
low (less)
Fade Mode: OFF <<
Fade Time: The time over which the LFO amplitude will reach the
maximum after the Delay Time has elapsed.
Delay Time: The time from when the keyboard is released until the
LFO begins to be applied.
● Apply the LFO from when the key is pressed
until it is released, and gradually begin to
decrease the effect when the key is released
fig.LFO-4.e
high (more)
Pitch
Cutoff Frequency
Level
Pan
low (less)
Note on
Note off
Fade Mode: OFF >>
Fade Time: The time over which the LFO amplitude will reach the
minimum after the Delay Time has elapsed.
Delay Time: The time that the LFO will continue after the keyboard
is released.
Fade Time
Depth
Fade Time
Depth
Fade Time
Depth
Delay
Time Fade Time
Depth

Setting Effects for a Patch (Effect)

Routing
fig.03-28_50
MFX Send (MFX Send Level) ★
Sets the level of the signal sent to MFX.
Value: 0–127
CHO Send (Chorus Send Level) ★
Sets the level of the signal sent to chorus.
Value: 0–127
REV Send (Reverb Send Level) ★
Sets the level of the signal sent to reverb.
Value: 0–127
Output Assign
Sets the direct sound's output method.
Value
MULTI: Output in stereo through MFX. You can also apply chorus or
reverb to the sound that passes through MFX.
MAIN: Output to the MAIN OUT jacks in stereo without passing
through MFX.
DIR: Output to the DIRECT OUTjacks in stereo without passing
through MFX. Make this setting when you want to use external
effects.
MFX (MFX On/Off Switch)
Switches MFX on and off.
Value: (OFF), (ON)
MFX Type
Use this parameter to select from among the 41 available MFX. For
details on MFX parameters, refer to "MFX Parameters" (p. 164).
Value: 00 (Thru)–41
MFX Master Level
Adjusts the volume of the sound that has passed through the MFX.
Value: 0–127
Creating a Patch
97