Roland V-Synth XT Owner's Manual page 129

Hide thumbs Also See for V-Synth XT:
Table of Contents

Advertisement

Settings Common to All Modes (System Mode)
KBD
fig.05-06_50
Local Sw (Local Switch)
The Local Switch determines whether the internal sound generator is
disconnected (OFF) from the controller section (Time Trip Pad and
so on); or not disconnected (ON). Normally this is left "ON."
Value: OFF, ON
Key Hold Panic Key
This specifies the key (note) that will stop all sounds being held by
the Key Hold function (p. 39).
Value: C2–C7
TT Pad
fig.05-07_50
X Assign-XY
Specifies the MIDI controller number that will be transmitted by
movements in the 'X' (horizontal) direction when the Time Trip pad
is in XY mode.
Value
OFF: No message will be transmitted.
CC01–31, 33–95: Controller numbers 1–31, 33–95
Y Assign-XY
Specifies the MIDI controller number that will be transmitted by
movements in the 'Y' (vertical) direction when the Time Trip pad is
in XY mode.
Value
OFF: No message will be transmitted.
CC01–31, 33–95: Controller numbers 1–31, 33–95
128
X Assign-TT (X Assign-Time Trip)
Specifies the MIDI controller number that will be transmitted by
movements in the 'X' (horizontal) direction when the Time Trip pad
is in Time Trip mode.
Value
OFF: No message will be transmitted.
CC01–31, 33–95: Controller numbers 1–31, 33–95
Y Assign-TT (Y Assign-Time Trip)
Specifies the MIDI controller number that will be transmitted by
movements in the 'Y' (vertical) direction when the Time Trip pad is
in Time Trip mode.
Value
OFF: No message will be transmitted.
CC01–31, 33–95: Controller numbers 1–31, 33–95
E1 - E8 Knob
Here you can create user sets (1–8) for the E1–E8 knobs. You can assign
the E1–E8 knobs to the knobs shown in the PATCH PLAY screen.
Procedure:
1. Touch the user set that you want to edit ([User1]–[User8]).
2. Touch the knob that you want to assign (E1–E8 Assign).
3. Use [INC]/[DEC] or the VALUE dial to select a parameter. The
screen shows the corresponding location in the PATCH
PLAY screen.
4. Repeat steps 2. and 3. until you've assigned all of the knobs.
5. When you're finished, touch <Write>.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents