Applying An Effect By Turning A Knob (E1-E8 Knobs) - Roland V-Synth XT Owner's Manual

Playing in Patch Mode
If > is on
<
The effect will be applied when you move your finger up/
down/left/right on the Time Trip pad.
fig.02-13
• By pressing TIME TRIP PAD <HOLD>, you can cause the effect
to be held even after you take your finger off the Time Trip pad.
• The Time Trip Pad settings are saved with each patch. This
means that you can create patches that contain Time Trip Pad
settings you like.
70
Applying an Effect by Turning a Knob
(E1–E8 knobs)
By turning the E1–E8 knobs while you play, you can control the
various functions that've been assigned to them.
1. Make sure the PATCH PLAY screen is displayed.
If the PATCH PLAY screen is not displayed, press [EXIT] once or
twice until the PATCH PLAY screen appears.
2. While playing your external MIDI keyboard to produce
sound, turn the E1–E8 knobs
The sound will change according to the function assigned to
each knob.
fig.Q-14
As shown in the following illustration, numbers (1–8) will
appear in the PATCH PLAY screen (p. 60); these correspond to
E1–E8.
In the PATCH PLAY screen, you can hold down the [SHIFT] key
and use the cursor up/down [
parameters that will be controlled.
In the Sound Shaper screen (p. 77), these correspond directly to
the eight on-screen knobs.
By assigning MIDI controller numbers to the E1–E8 knobs, you
can turn [E1]–[E8] to control an external MIDI device that is
connected. For details, refer to "E1–E8 Assign" (p. 129).
][ ] buttons to switch the