Figure 21: Installing the 2.5-inch HDD/SSD module
Ê Carefully push the HDD/SSD module into the empty slot (1) until it stops.
Ê Push the handle completely (2) in the direction of the arrow until the locking
mechanism engages.
8.1.3.4
Removing the HDD/SSD module
V
CAUTION!
Only remove an HDD/SSD module during operation if the drive is not
●
currently being accessed. Observe the control LEDs for the
corresponding HDD/SSD modules (see
HDD/SSD modules" on page
Under no circumstances should you remove an HDD/SSD module
●
while the system is in operation if you are not sure that the hard disk
drive or solid state disk is operated by a RAID controller and belongs
to a disk array that is operating in RAID level 1, 1E, 10, 5, 50, 6 or 60.
An HDD/SSD module can only be replaced during operation in
conjunction with a corresponding RAID configuration.
All HDD/SSD modules (drives) must be uniquely identified so that
●
they can be reinstalled in their original mounting locations later. If this
is not done, existing data can be lost.
RX600 S6
62).
Operating Manual
CSS components
"Indicators on the hot-plug
99