5.2
Switching the server on and off
V
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page
The On/Off button does not disconnect the server from the mains
●
voltage. To completely disconnect it from the mains voltage, remove
the power plug(s) from the socket(s).
Do not move, strike, or shake the server when it is turned on. This can
●
damage the hard disk in the server and cause data loss.
Turn the server on when the temperature is in its operating
●
environment range (10 – 35°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly, damage data etc. Furthermore, Fujitsu cannot be held
responsible for any related damage, malfunction, or loss of data, etc.
Be sure to wait for 10 seconds or more after shutdown before turning
●
the server on.
After connecting the power cords, press the On/Off button after it
●
passes for more than 10 seconds.
Switching the server on
The power-on indicator (see
mode) when the server is connected to the mains.
– Starting up for the first time:
For the Japanese market, please refer to " はじめにお読みください ".
Ê Press the On/Off button (see
Ê Insert ServerView Suite DVD 1 in the DVD drive.
Ê Follow the on-screen instructions (see also section
server and installing the operating system with the ServerView
Installation Manager" on page 73
installing the operating system without the ServerView Installation
Manager" on page
RX600 S6
figure 8 on page
figure 8 on page
or section
74).
Operating Manual
Starting up and operation
79).
58) lights up orange (standby
58).
"Configuring the
"Configuring the server and
69