[H-Area Position]; [V-Area Position]; [Left Masking Area]; [Right Masking Area] - Panasonic PT-AE8000U Operating Instructions Manual

[LENS CONTROL] menu

[H-AREA POSITION]

You can move the frame area horizontally, such as
aligning the right or left frame edge to the screen
edge.
Moving left
For example, when projecting an overscanned 16:9
projection area at a 4:3 aspect ratio on a 4:3 aspect
screen, you can adjust the horizontal discrepancy
between the screen position and the video display
position.
16:9 projection area
4:3 video display position

[V-AREA POSITION]

You can move the frame area vertically, such as aligning
the top or bottom frame edge to the screen edge.
Moving
downward
For example, when projecting an overscanned 16:9
projection area at a 2.35:1 cinema scope screen
movie on a 2.35:1 size cinema scope screen, you can
adjust the vertical discrepancy between the screen
position and the video display position.
16:9 projection area
2.35:1 cinema scope screen

[LEFT MASKING AREA]

You can place a blank (mask) area in the left side edge on
the screen.
Less
z Setting range: 0 to 70
76 - ENGLISH
Moving right
4:3 screen
Moving upward
2.35:1 cinema scope screen
size video display position
More

[RIGHT MASKING AREA]

You can place a blank (mask) area in the right side edge on
the screen.
Less
z Setting range: 0 to 70

[UPPER MASKING AREA]

You can place a blank (mask) area in the upper side edge
on the screen.
Less
z Setting range: 0 to 70

[LOWER MASKING AREA]

You can place a blank (mask) area in the lower side edge
on the screen.
Less
z Setting range: 0 to 70
Note
z If it is set to [0], each masking function will be invalid.
z The [MASKING AREA] function will be invalid when
adjusting the [COLOR MANAGEMENT] or [SPLIT
ADJUST] settings, when displaying the [TEST PATTERN]
or [WAVEFORM MONITOR], or when no signal is
detected.
z During the display of 3D images, you cannot use [LEFT
MASKING AREA], [RIGHT MASKING AREA], [UPPER
MASKING AREA], [LOWER MASKING AREA].

[PROCESSING MESSAGE]

You can set whether to show or hide the execution
message during switching of lens settings.
Switch settings
[ON] Show the execution message
[OFF] Hide the execution message
More
More
More
Switch settings