Panasonic PT-AE8000U Operating Instructions Manual page 65

Note
z If a setting other than [AUTO] is selected when the input is switched to HDMI, [3D INPUT FORMAT] is changed to [AUTO]
when actions such as turning the power of/on, switching input, or switching the signal are performed on the connected
device.
See the following table regarding settings, input signals and the image for viewing.
Switching 3D
format
Input signal
FRAME
PACKING
(Normal 3D video)
SIDE BY
SIDE
(Normal 3D video
TOP AND
BOTTOM
(Normal 3D video
2D
*1 Depending on the signal, it is necessary to set [3D INPUT FORMAT]. (
z During 2D to 3D conversion, [3D INPUT FORMAT] cannot be performed.
z Depending on the device connected, there are cases where it differs from the content described above.
z A FRAME PACKING signal is a 3D signal for when a Blu-ray 3D compatible disc is played back with a device such as a 3D
compatible Blu-ray player connected using HDMI.
z The SIDE BY SIDE signal uses two videos arranged next to each other and converts them to a 3D video.
z A TOP AND BOTTOM signal is when two videos are arranged on top of each other are used and converted to a 3D video.
z When the freeze function is being used, the [3D INPUT FORMAT] cannot be executed.
z As regards the "Normal 3D video" shown in the table, a 3D video is available when power is supplied to the 3D Eyewear.
The 3D effect is not achieved if the power supply is cut off.
[AUTO] [SIDE BY SIDE]
*1 ) (Normal 3D video)
*1 )
[3D SETTINGS] menu
[TOP AND
BOTTOM]
(Normal 3D video)
 page 64)
ENGLISH - 65
[NATIVE]