Control Commands - Panasonic PT-AE8000U Operating Instructions Manual

■ Cable specifications
(When connected to a personal computer)

■ Control commands

Commands available when controlling this projector from a computer are as follows.
<Operation commands>
Command Control contents
PON POWER ON
POF POWER OFF
SWITCH
IIS
INPUT
OMN MENU
OEN ENTER
OBK RETURN
OCU
OCD Navigation buttons
OCL (▲▼◄►)
OCR
OLE LENS
OST DEFAULT
OFZ FREEZE
FC1 FUNCTION BUTTON Activates the function allocated to the <FUNCTION> button of the remote control.
OSH BLANK
OVM PICTURE
OMM MEMORY LOAD
OWM WAVEFORM
VS1 ASPECT
VPM PICTURE MODE
DPA PICTURE ADJUST
COLOR
DCM
MANAGEMENT
OVL VIERA LINK
OSM SUB MENU
Projector
In standby mode, all commands other than the PON command are ignored.
The PON command is ignored during lamp on control.
zIf a PON command is received while the cooling fan is operating after the lamp has
switched off, the lamp is not turned back on unless approximately 85 seconds have
passed in order to protect the lamp.
Parameters
CP1 = COMPONENT IN SVD = S-VIDEO IN
VID = VIDEO IN HD1 = HDMI 1 IN HD2 = HDMI 2 IN HD3 = HDMI 3 IN
RG1 = COMPUTER IN
Displays the main menu.
Activates the selected items in the menu mode.
Returns to the previous menu or escaping from the menu mode.
OCU = ▲ cursor
OCL = ◄ cursor
Displays the test patterns for adjusting [ZOOM/FOCUS].
([RETURN] or [MENU] when finishing)
Resets to the factory default setting. (
Freezes the projected screen. (
0 = OFF, 1 = ON
Turns off the projection temporarily.
Sends the command to switch between ON and OFF. (
Do not rapidly switch between ON/OFF.
While the BLANK function is ON, it is switched OFF when any command is received.
Activates the [PICTURE] menu. Send the command to switch menu items.

( page 40)
Displays the [MEMORY LOAD] menu.
Parameter
0 = OFF 1 = FULL SCAN(Y) 2 = FULL SCAN(R) 3 = FULL SCAN(G)
4 = FULL SCAN(B) 5 = SINGLE LINE SCAN(Y) 6 = SINGLE LINE SCAN(R)
7 = SINGLE LINE SCAN(G) 8 = SINGLE LINE SCAN(B)
Switches the aspect ratio. Aspect ratio is switched each time this command is sent.

( page 61)
Switches the [PICTURE MODE]. (
Parameter
NOR = NORMAL DYN = DYNAMIC 709 = REC709 DCN = D-CINEMA
CN1 = CINEMA1 CN2 = CINEMA2
Displays the individual adjustment screen of the [PICTURE] menu operated immediately before
this operation.
Displays the [COLOR MANAGEMENT] menu.
Displays the [VIERA LINK] menu.
Displays the SUB MENU of the connected equipment, when [VIERA LINK SETTING] - [VIERA
LINK] is [ON], and the "VIERA Link" compatible device and CEC-compatible equipment of other
manufacturers is connected. For details on the CEC-compatible equipment of other manufacturers,
see page 97.
Technical information
1 NC NC 1
2 2
3 3
4 NC NC 4
5 5
6 NC NC 6
7 7
8 8
9 NC NC 9
Remarks
OCD = ▼ cursor
OCR = ► cursor

page 33)

page 83)

page 83)

page 40)
GM1 = GAME
PC (DTE)
ENGLISH - 103