TEMP and LAMP Indicators
Managing the indicated problems
If a problem should occur with the projector, the lamp indicator <LAMP> and/or temperature indicator <TEMP>
will illuminate or flash. Check the indicator status and deal with problems as follows.
Attention
z When switching off power to deal with problems, ensure that you follow the procedure in "Switching off the power".
(
page 30)
Note
z Check the status of the power supply with the power indicator <ON (G)/STANDBY (R)>. (
Temperature indicator
■ Temperature indicator <TEMP>
z Illuminates red during projection.
Indicator
(Alert indicating [REFER TO THE "TEMP indicator" SECTION IN THE OPERATION MANUAL.] is
status
displayed.)
z Flashing red when power is turned off (projection stops automatically).
Problem
The temperature inside and/or outside the projector is abnormally high.
The air intake and
Cause
exhaust ports may
be obstructed.
Remove object(s)
from the ventilation
Solution
ports or clear the
area around the
projector.
Note
z If the <TEMP> indicator is illuminated or flashes despite taking the actions above, please contact your dealer to have your
projector repaired.
Lamp indicator
The air filter unit
The room
may be excessively
temperature may
dirty and ventilation
be too high.
may be poor.
Place the projector
in an environment
with temperature
Clean or replace
and humidity as
the air filter unit.
designated in the
(
page 87)
specifications.
(
page 106)
TEMP and LAMP Indicators
page 28)
The projector may be being
used at high elevations
(1 400 m (4 593 ft) or more
above sea level).
The projector can only be
used for two minutes after
turning on. Set [HIGH
ALTITUDE MODE] to [ON]
within two minutes of turning
the projector on.
(
page 80)
ENGLISH - 85