[Startup Logo]; [Auto Search]; [Hdmi Signal Level]; [Frame Response] - Panasonic PT-AE8000U Operating Instructions Manual

[OPTION] menu

[STARTUP LOGO]

You can switch the Panasonic logo that is displayed
when starting up the projector on/off.
Switch settings
[ON]
[OFF]
Note
z The logo Panasonic is displayed for 15 seconds.

[AUTO SEARCH]

Sets whether to automatically search for terminals
that have an input signal when the projector is turned
on.
Switch settings
[ON]
[OFF]
Attention
z Set this to [ON] under normal circumstances.
z When no signal is detected, the last used input will be
selected.

[HDMI SIGNAL LEVEL]

If video is not displayed correctly when this projector
is connected to an external device via an HDMI
connection, switch the settings.
Switch settings
[NORMAL]
[EXPAND]
Note
z This may not work correctly with some external devices,
and problems such as video not being displayed may
occur.
78 - ENGLISH
Switch settings
Active
Inactive
Switch settings
Active
Inactive
Switch settings
Signal level used by general
external devices
Expanded signal level used by
some devices

[FRAME RESPONSE]

Switch this setting when a progressive signal is
input and you wish to reduce the time taken from the
signal being input to the video being displayed on the
screen.
Switch settings
[NORMAL] Prioritizes the image quality
[FAST] Prioritizes the frame response
Note
z [NORMAL] allows higher quality image viewing.

[PROJECTION METHOD]

Set the projection method according to the projector
installation status. Change the projection method if
the screen is displayed upside down or the display is
reversed. (  page 21)
Switch settings
When setting on a desk/floor and
[FRONT/DESK]
projecting from the front
When using the ceiling mount
[FRONT/
bracket (optional accessory) and
CEILING]
projecting from the front
When setting on a desk/floor and
[REAR/DESK] projecting from the rear (using a
translucent screen)
When using the ceiling mount
[REAR/ bracket (optional accessory) and
CEILING] projecting from the rear (using a
translucent screen)
Switch settings
Switch settings