Panasonic PT-AE8000U Operating Instructions Manual page 47

Display the currently selected
point number. The number is in
the order of 1 to 15 starting from
POINT
the lower input level. The selected
point flashes in yellow on the
adjustment screen.
Display the input level of the
currently selected point. Can
be set in the range of 1 to 99%
in increments of 1%. When
dispatching from the factory, the
INPUT
input level is set in the order of
5%, 10%, 15%, 20%, 25%, 30%,
35%, 40%, 45%, 50%, 60%, 70%,
80%, 90%, and 95% starting from
point 1.
Display the output level of the
currently selected point. The
difference from the standard value
OUTPUT can be set in the range of -252
to +252. The adjustable range
depends on the input level. The
standard value is 0.
6) Change the POINT, adjust the INPUT level,
and also adjust the OUTPUT level.
z In the screen displayed in 5), select any one
from [Y], [R], [G], or [B], and then perform the
operation after pressing the <ENTER> button.
The respective operations are described below.
a. Changing the point to be adjusted
z Press the ◄► buttons to move the cursor for
selecting the point, to the left or right.
ADVANCED ADJUST
►
Press the button to move one point to the right.
PICTURE GAMMA PRESET
◄
Press the button to move one point to the left.
REFERENCE POINTS
POSITION
Y
LANGUAGE
3D SETTINGS
LENS CONTROL
OPTION
0%
POINT 8
+0.40
ON
R G B
50% 100%
INPUT 40% OUTPUT -16
b. Adjusting the input level (only [Y])
z Press the <SUB MENU> button to set the
[OPERATION MODE] to [INPUT ADJUSTMENT].
See the operation guide to check if the current
status is the [CHANGE POINT] mode or the [INPUT
ADJUSTMENT] mode.
Operation Guide
CHANNEL
CHANGE
OPERATION MODE
CHANNEL
CHANGE
OPERATION MODE
z If you press the ◄► buttons, you can adjust the
input level of the currently selected point.
The input level can be set in the range of 1 to 99%
in increments of 1%. However, you cannot set an
input level more than that of the adjoining points.
Note
z The input level can be adjusted only when [Y] is being
adjusted.
ADVANCED ADJUST
The input level cannot be adjusted when [R], [G], or [B]
PICTURE GAMMA PRESET
are being adjusted.
REFERENCE POINTS
◄
Ex: When the
POSITION
Y
LANGUAGE
3D SETTINGS
LENS CONTROL
OPTION
0%
ADVANCED ADJUST
PICTURE GAMMA PRESET
POINT 8
REFERENCE POINTS
POSITION
LANGUAGE
3D SETTINGS
Move left
LENS CONTROL
OPTION
0%
POINT 8
[PICTURE] menu
RESET
(RESET ALL: 3 sec)
OUTPUT ADJ. CHANGE POINT
RETURN
SET AS NEW REF.
RESET
(RESET ALL: 3 sec)
OUTPUT ADJ. INPUT ADJ.
RETURN
SET AS NEW REF.
0.0
ON
button is pressed on [Y].
R G B
50%
0.00
INPUT 40% OUTPUT
ON
50%
INPUT 37% OUTPUT
ENGLISH - 47
100%
0
100%
+8