Table of Contents
Advertisement
5.2.4
PROCHOT# Signal
An external signal, PROCHOT# (processor hot), is asserted when the processor die
temperature has reached its maximum operating temperature. If the Thermal Monitor
is enabled (note that the Thermal Monitor must be enabled for the processor to be
operating within specification), the TCC will be active when PROCHOT# is asserted. The
processor can be configured to generate an interrupt upon the assertion or de-
assertion of PROCHOT#. Refer to the Intel
Developer's Manuals for specific register and programming details.
The processor implements a bi-directional PROCHOT# capability to allow system
designs to protect various components from over-temperature situations. The
PROCHOT# signal is bi-directional in that it can either signal when the processor has
reached its maximum operating temperature or be driven from an external source to
activate the TCC. The ability to activate the TCC via PROCHOT# can provide a means
for thermal protection of system components.
One application is the thermal protection of voltage regulators (VR). System designers
can create a circuit to monitor the VR temperature and activate the TCC when the
temperature limit of the VR is reached. By asserting PROCHOT# (pulled-low) and
activating the TCC, the VR can cool down as a result of reduced processor power
consumption. Bi-directional PROCHOT# can allow VR thermal designs to target
maximum sustained current instead of maximum current. Systems should still provide
proper cooling for the VR, and rely on bi-directional PROCHOT# only as a backup in
case of system cooling failure. Refer to the Voltage Regulator-Down (VRD) 10.1 Design
Guide For Desktop and Transportable LGA775 Socket for details on implementing the
bi-directional PROCHOT# feature.
5.2.5
THERMTRIP# Signal
Regardless of whether or not Thermal Monitor or Thermal Monitor 2 is enabled, in the
event of a catastrophic cooling failure, the processor will automatically shut down when
the silicon has reached an elevated temperature (refer to the THERMTRIP# definition in
Table
25). At this point, the FSB signal THERMTRIP# will go active and stay active as
described in
does not generate any bus cycles.
5.2.6
T
CONTROL
T
CONTROL
thermal diode. The value for T
configured for each processor. When T
T
as defined by the thermal profile in
C-MAX
processor temperature can be maintained at T
thermal diode.
The purpose of this feature is to support acoustic optimization through fan speed
control. Contact your Intel representative for further details and documentation.
5.2.7
Thermal Diode
The processor incorporates an on-die PNP transistor whose base emitter junction is
used as a thermal "diode", with its collector shorted to Ground. A thermal sensor
located on the system board may monitor the die temperature of the processor for
thermal management and fan speed control.
provide the "diode" parameter and interface specifications. Two different sets of "diode"
parameters are listed in
apply to traditional thermal sensors that use the Diode Equation to determine the
82
Table
25. THERMTRIP# activation is independent of processor activity and
and Fan Speed Reduction
is a temperature specification based on a temperature reading from the
CONTROL
Table 30
Thermal Specifications and Design Considerations
®
64 and IA-32 Architecture Software
will be calibrated in manufacturing and
is above T
DIODE
CONTROL
Table 28
and
(or lower) as measured by the
CONTROL
Table
30,
Table
and
Table
31. The Diode Model parameters
, T
must be at or below
C
Figure
12; otherwise, the
31,
Table
32, and
Table 33
(Table
Datasheet
30)
Advertisement
Table of Contents
