Ip Ospf Transmit-Delay - Dell Force10 S2410-01-10GE-24P Command Reference Manual

ip ospf retransmit-intervalr seconds
Syntax
The value for seconds is the number of seconds between link-state advertisement retransmissions for
adjacencies belonging to this router interface. This value is also used when retransmitting database and
link-state request packets.
Range: 0 to 3600 seconds (1 hour)
The no ip ospf retransmit-interval command sets the OSPF retransmit interval for the specified
interface to the default.
Default 5 (seconds)
Mode Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
Version 2.3
History
Related interface range
Commands
interface vlan

ip ospf transmit-delay

This command sets the OSPF transit delay for the specified interface.
ip ospf transmit-delay seconds
Syntax
The transmit delay is specified in seconds. In addition, it sets the estimated number of seconds it takes
to transmit a link state update packet over this interface.
Range: 1 to 3600 (1 hour)
The no ip ospf transmit-delay command sets the OSPF Transit Delay for the specified interface to
the default.
Default 1
Mode Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
Version 2.3
History
Related interface range
Commands
interface vlan
Added Interface Range and Interface VLAN modes.
Defines an interface range and accesses the Interface Range mode
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
Added Interface Range and Interface VLAN modes.
Defines an interface range and accesses the Interface Range mode
Creates a VLAN or selects an existing one and enters the Interface VLAN mode.
OSPF Commands | 437