Configuring An Interface With An Ip Address; Using The Show Ip Interface Command - Dell Force10 S2410-01-10GE-24P Configuration Manual

Configuring an Interface with an IP Address

Note: You must have the optional SFTOS Layer 3 Package installed to configure routing
commands and to set IP addressing an interface. Use the show version command (see
Figure 3-8 on page
To assign an IP address to an interface, use the following commands:
Command Syntax
ip routing
ip address
Force10 #configure
Force10 (Config)#ip routing
Force10 (Config)#interface 1/0/3
Force10 (Interface 1/0/3)#ip address 50.0.0.2 255.255.255.0
Force10 (Interface 1/0/3)#routing
Note: You must configure ip routing at a global level, AND 'routing' at an interface level for you to
be able to ping from, and to, the address.
Note: To configure the management interface with an IP address, see
Address on page
IP configuration takes precedence over VLAN configuration on a port. Therefore, configuring an IP
Address and 'routing' on an interface disables participation in VLANs on that interface.

Using the Show IP Interface Command

Use the
show ip interface
Figure 3-15. Using the show ip interface Command
Force10 #show ip interface 1/0/3
IP Address..................................... 50.0.0.2
Subnet Mask.................................... 255.255.255.0
Routing Mode................................... Enable
Administrative Mode............................ Enable
Forward Net Directed Broadcasts................ Disable
Active State................................... Active
Link Speed Data Rate........................... 1000 Full
MAC Address.................................... 00:03:E8:0D:20:01
Encapsulation Type............................. Ethernet
IP Mtu......................................... 1500
Force10 #
40 | Getting Started
35) to determine what software is installed.
Command Mode
Global Config
Interface Config
39.
command to display information about a particular IP interface:
Purpose
Enables routing for the switch.
Configures an IP address on an interface. The IP
address may be a secondary IP address.
Setting the Management IP