Packing The Copier - Xerox XC 800 Series User Manual

Packing the Copier

2
1
44
1. Disconnect the power cord.
Note: When carrying the copier, do not hold
onto the exit tray and do not insert your hand
into the exit tray.
2. Remove the SDF exit tray.
2. Press the release lever to open the copier.
3. Remove the toner cartridge.
4. Close the copier.
1. Open the paper tray(s), and remove the
copy paper.
2. Attach the pressure plate lock(s). Firmly
close the paper tray.
Note: The pressure lock storage
compartment is just inside the open copier.
8. Replace the shipping pins into the right
and left sides of the copier.
Note: The shipping pins are stored on the
underside of the exit tray.
XC810/ XC1040/ XC1045 copiers only
Note: Insert foam between the shipping pin
head and the alternate paper tray to protect
the tray.
9. Fold up the exit tray and the alternate
paper tray (XC810/ XC1040/ XC1045
copiers only).
10. Securely tape the exit tray, alternate paper
tray, and the document cover closed.
11. Pack the copier by reversing the
Unpacking instructions. (Refer to
Installation.)