Table of Contents
Advertisement
Installation
10
13. Remove the starter toner cartridge from
the bag. Vigorously shake the cartridge to
loosen the toner.
Thoroughly shaking the cartridge will
•
assure maximum copies per cartridge.
Xerox has included a Starter Toner
•
Cartridge for your convenience.
Purchased replacement toner
cartridges will yield approximately twice
the number of copies.
14. Remove the toner cartridge cover.
10. Slide the toner cartridge into the copier
until it locks into place.
11. Close the copier by gently pushing down
the upper half.
Step 17 for XC865/ XC1044/ XC1045/
XC1255 copiers only
17. Inset the front tab of the SDF exit tray into
the front notch. Slide the tray to the front,
and then insert the rear tabs into the rear
notches.
Advertisement
Table of Contents
