Xerox XC 800 Series User Manual page 18

Control Panel
5. Paper Supply Selection
Press to change the selected paper supply. The selected paper supply
location will be indicated by a green light on the copier diagram.
6. Copier Diagram: Helps you locate areas that require your attention.
The indicators will flash in the area requiring attention.
7. Preset Reduction/Enlargement: Press this key to select any of the
preset reductions or enlargements.
• The
factory for 70%. Refer to Customizing Your Copier for
information about changing this percentage.
8. Variable Percentage Indicator: The indicator will light when a variable
percentage is selected.
9. %: Press this key to display the selected reduction/enlargement.
10. Variable Percentage: Press the down key to decrease the
percentage. Press the up key to increase the percentage. Any
percentage from 70% to 141% may be selected.
•
The indicator above the % key will light when a variable percentage
is selected.
11. Display Window: Copy quantity, reduction/enlargement settings, and
status codes appear in this area.
12. Quantity Keys: Select up to 100 copies. Press the ones key (right
key) to increase the quantity by one. Press the tens key (left key) to
increase the quantity by 10.
•
To display the number of copies requested during the copy run
press the tens key.
•
Press the Clear key to clear the selected quantity.
13. Clear/Stop: Press this key to stop the copier while making copies or
to clear copy quantity. If the key is pressed consecutively, all
programming will be cleared.
14. Start: Press this key to begin copying.
•
The display will change to 1 and increases by 1 as each copy is
made.
15. Ready Indicator: When the light is ON (not flashing), the copier is
ready to make copies. When the light is flashing after the Start key is
pressed, the copier is warming up and the copy cycle will begin
automatically.
(XC810/ XC1040/ XC1045/ XC1250/ XC1255):
(customer settable) percentage has been set at the
13