Packard Bell EasyNote NS11HR Service Manual page 86

80
CHAPTER 3: Replacing notebook components
4
Remove the LCD front panel screws.
5
Carefully pry loose the front panel from the LCD assembly lid. Start on the
bottom side, continue to the left and right sides, and finally the top side.
Remove the front panel.
6
Place the new front panel on top of the LCD assembly lid.
Make sure that the LCD, webcam, microphone, and antenna cables are
properly routed on the hinge sides.
7
Press the front panel on all sides until it snaps into place.
Make sure that there is no gap between the front panel and the LCD
assembly lid.
8
Secure the front panel with screws removed in
9
Return the LCD front panel screw covers to their places.
10
Reinstall the LCD panel assembly by following the
"Replacing the LCD panel assembly"
11
Reinstall the system board by performing
the system board"
12
Reinstall the keyboard by performing
keyboard" procedure on
13
Reinstall the palm rest module by performing
the palm rest module"
14
Reinstall the optical drive by performing
the optical drive"
15
Reinstall the hard drive by performing
hard drive" procedure on
procedure on page
page 53.
procedure on page
procedure on page 46.
page 41.
step 4.
steps 13
procedure on page 76.
steps 19 and 20 of the
67.
steps 21 – 24 of the
steps 14 – 17 of the
48.
steps 10 and 11 of the
steps 8 and 9 of the
– 15 of the
"Replacing
"Replacing the
"Replacing
"Replacing
"Replacing the