Replacing The Palm Rest Module - Packard Bell EasyNote NS11HR Service Manual

Replacing the palm rest module

48
CHAPTER 3: Replacing notebook components
Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
3 black M2.5×6 (bay cover)
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
To replace the palm rest:
1
Complete the steps in
2
Complete the steps in
3
Complete the steps in
4
Remove the hard drive screw, and then remove the hard drive from its
compartment.
5
If the notebook has a wireless card installed, unplug the antenna cables.
or Non-marring plastic scribe
9 black M2.5×6 (palm rest - base side)
"Preparing the notebook" on page
"Removing the battery" on page
"Removing the bay cover" on page
37.
38.
39.