Table of Contents
Advertisement
General Information
S100 NFU Steering Lever
The S100 Non-follow-up steering lever is designed for indoor
console mounting and it has a spring-loaded return-to-
mid-position feature.
S35 NFU Steering Lever
The S35 is designed for indoor and outdoor bulkhead-mounting
and is made of shock resistant polyxymethylene. The lever has a
spring loaded return-to-mid-position feature. Its push button
with light indicator is used for (limited) mode selection when
connected to an autopilot junction unit.
FU50 Follow-Up Steering Lever
The FU50 Follow-up steering lever features a dial (scale) with
5° rudder angle markings. The rudder will move and stop at the
angle selected on the dial. The FU50 has a mid-position indent,
buttons for (limited) mode selection, and mode indicators
(STBY, FU, AUTO, NAV, WORK, and THRUSTER). It is
designed for indoor and outdoor bulkhead- or panel-mounting.
Refer to the FU50 manual.
F1/2 NFU Remote
This handheld control for push-button steering is fitted with a
rubber grip and is made of cast seawater-resistant aluminum. It
is fitted with a 10 meter (33 ft.) cable.
TI50 Thruster Interface
The TI50 Thruster Interface is designed to provide a control
signal for operating a thruster in an AP50 system by either
on/off solenoids, analog ±10V control, or Danfoss PVEM valve.
The thruster output signal is calculated in the TI50 based on
operational mode and heading information received over
RobNet from other system units. Set-up from the control unit
and errors in the thruster interface are to be communicated via
RobNet. All settings are stored in the thruster interface unit.
Refer to the TI50 manual.
17
20221032B
Advertisement
Table of Contents
