Toshiba e-STUDIO453 Service Manual page 58

(5) Remove 5 screws and take off the SYS
board case.
2 2
[D] NIC board / System control PC board
(SYS board)
(D-1) e-STUDIO350/450
(1) Take off the rear cover (
[C]).
(2) Take off the hard disk with the whole SYS
board lower cover (
(3) Disconnect 5 connectors.
(4) Remove 2 screws, release 1 lock support.
Then take off the NIC board.
(5) Remove 10 screws, take off the SYS board.
e-STUDIO350/352/353/450/452/453
OUTLINE OF THE MACHINE
Chapter 2.5.1
Chapter 2.5.2 [B]).
2 - 38
05/11
Fig. 2-544
Fig. 2-545
Fig. 2-546
SYS board
Fig. 2-547
© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
SYS board case
NIC board