Selecting Luminance Units; Selecting Units Of Length; Setting Up Optical Sensor List And Priority - Barco MediCal Pro Installation & User Manual

Hide thumbs Also See for MediCal Pro:

Table of Contents

3.10 Selecting Luminance units

The results and values of luminance measurements can be expressed

in Candela per square meter (Cd/m²) or Footlambert (fL).

To select the luminance units:

1 From the Tools menu, select Options > Application Settings (see

above).

2 Select the General tab (see above).

3 Select the desired luminance unit.

In the Display properties, you can enter the screen size of the displays.

You can do this in inches or millimeters. You can select this unit of length

in the Application Settings dialog.

To select the units of length:

1 From the Tools menu, select Options > Application Settings (see

above).

2 Select the General tab (see above).

3 Select the desired unit of length.

MediCal Pro supports a list of possible optical sensors. To speed up the

search for connected optical sensors, it is best to indicate which sensor

types are used and which ones are not used.

Moreover, you can set up a priority of sensors. This may be necessary

when using Barco flat panel displays with built-in I-Guard sensor. When

you wish to use an external sensor for measurements on the flat panel,

you should assign it a higher priority than the I-Guard sensor. In that case,

MediCal Pro will automatically select the external sensor for the

measurements.

To set up the list and priority of used sensors:

1 From the Tools menu, select Options > Application Settings (see

above).

2 Select the Sensor Setup tab.

Using MediCal Pro

Table of Contents